I just finished making my very first Evil Twins cube. It is for Martywolfman and I sure hope he likes it!
I used this tutorial to make the cube: http://www.youtube.com/watch?v=u_ki9XR7ttI
One cubie (blue/orange) is not sitting to my liking but psh. This is looking good enough, so I wager it'll be satisfactory. The innards after sanding are looking gray instead of black though, maybe that can be sorted with a black marker, but I am not touching the thing again to modify stuff. Martywolfman can do that if he so wishes.
First off I made a fused cube to start out with. You cannot see it in this picture but one core has a special message written on it and the date that I started on this cube.
fusedprogress1.jpg [ 29.34 KiB | Viewed 843 times ]
Proceeding to remove the stickers that weren't needed and marking the pieces where they needed to be extended. I love Tipp-Ex now
fusedprogress3.jpg [ 35.31 KiB | Viewed 843 times ]
Let's add all the pieces in their correct spots to make sure I have the correct ones before I start chopping.
fusedprogress4.jpg [ 45.78 KiB | Viewed 843 times ]
Next steps is filling up the cubies, I used silicone, not quite to the top, and then finished things off with milliput which I later sanded.
fusedprogress5.jpg [ 36.54 KiB | Viewed 843 times ]
fusedprogress7.jpg [ 19.1 KiB | Viewed 843 times ]
Just four more pieces left to glue in.
fusedprogress8.jpg [ 33.12 KiB | Viewed 843 times ]
And all done! I measured it just now and it is a 75mm cube. The single cube I started with weighs 86g, this Evil Twins racks up a total of 241g.
fusedprogress9.jpg [ 44.96 KiB | Viewed 843 times ]
Needless to say when you turn this puzzle it makes for some cool movement.
fusedprogress11large.jpg [ 90.76 KiB | Viewed 843 times ]
Thanks for watching