Joined: Thu Jan 24, 2002 1:10 am Location: Toronto, Canada
If the measurements match as well as you say they do, it would not only work, but would be fairly simple to make.
Your biggest problem might be cutting around the mechanism for the extra cubie on the 5x5x5. Actually, you could just cut the 3x3x3, and glue the sucker on the 5x5. As long as the 3x3x3 is below the rotation plane of the 5th slice on the 5x5x5, it'll work fine.
While you're at it, you may as well tack on a 2x2x2 to the opposite side of the 3x3x3.
Users browsing this forum: No registered users and 5 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum