So I had this idea today while solving my rex cube. If you could take a rex cube design, and turn it like a helicopter cube. The pieces would move like this:
File comment: How the pieces would move.
rex.jpg [ 55.68 KiB | Viewed 1043 times ]
. So that's two "center" (middle squares) pieces, four triangle pieces, and one "edge" piece (true center piece). I was going to try to make it by putting rex cube pieces on the helicopter cube core, but then realized that the rex cube pieces were to small! I considered truncating the center piece, but then realized that it wouldn't help the problem. However, doing that would help the fact that the false center piece (the middle square) is too big! So I would need to truncate the center pieces, and extend the triangle pieces.
Any thoughts? Ideas?