Where is possible to get the coloured stickers for restickered it ?

http://twistypuzzles.com/cgi-bin/puzzle.cgi?pkey=2942

Try Oliver's Stickers

You where faster then me!

If you gave me the measurements, I'll make the design, and upload the sticker set to my shop within a few days.

Ok thanks
I'll send you te measurements next days

I asked Hanyama if they would ever make a standard size black body 6 color version.

And they said "No, Because it looks difficult to fit in Japanese market"

the square stickers (1,7 x1,7 cm)

the rectangular ones (2,7 cm x 1,7 cm)

thanks

The Hanayama 1x2x5 stickers are available in my shop



I hope you like the color scheme. If not, when you buy it, during the checkout, please leave a note, how you want to change it.

ordered

thanks

Nice!

Has anyone successfully dyed one yet? If so, any tips?

Bmenrigh has a great Video demonstrating how to dye ABS black.

Yes, but I'm wondering about this puzzle specifically. Disassembly issues, etc.

Is it just me, or hollow, stickers, would be cool, on that puzzle to, .

Oliver

The stickers are perfect

Thanks

I finally had a chance to dye my iQube 1x2x5:



Note that the stickers are hand cut from vinyl sheet and were made to cover the labels that came on the puzzle. In fact, they've were applied over the original labels, removed (so I could remove the stock labels) and reapplied, then removed (for the dying) and reapplied again. So if they look a little battle damaged, they've earned it. I plan to order replacements from Olivér Nagy.



The dying went well. The process is a bit tricky as the puzzle can't be disassembled and hence it both floats and partially fills with the solution, requiring some effort to first keep it submerged, and later to get it dry. I left it overnight in an "x" shape to air out, then all day flat on an absorbent paper towel and it seems to have fully dried.



I started off with far too little acetone so the color was being taken up very slowly - only a gradual darkening over 40 minutes. Once I upped the concentration - the puzzle darkened very quickly, getting nearly jet black in 15 minutes.



Even after that, the inside of the "deep cut" turn was still red when I checked so I made the mistake of adding more acetone; the result is a bit cloudy and there are slight blemishes in the plastic where I squeezed too hard with tongs when the plastic had softened, but it's not noticeable with the stickers.