Joined: Sun Mar 06, 2011 12:46 pm Location: Wichita
I dont think a 4x4 version could be made because the cuts would have to be angled on the top and bottom like on a master kilominx but straight on the sides.
And the problem with the screws is that the heads were too large to fit on the top and botom faces of the puzzle so they had to be cut down very small. The entire puzzle was close to not even working but I was able to make it work by making the center pieces smaller and grinding down the screw heads.
Users browsing this forum: No registered users and 17 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum