So in year 9 we go through a range of DT's that are split up, one is product design which basically impliments the graphics side of designing and the resistant materials part of making. I used a program called 2D Design to design a mobile phone holder, the pictures below show the prototype but it'll will be made in acrylic soon. Drawing the ghost cube was pretty damn hard to do on a computer but I think it vaguely represents it Feedback would be greatly appreciated, likes and dislikes etc
Sorry for bad pictures :L

That is a very good idea! The prototype is looking really good so far. You should consider making a whole in the back of the holder to connect a charger, if you haven't already.

Good idea, I could do that, Ill do it so it'll fit a iphone style charger because with blackberrys they come out the side of the phone anyway :p